Holeshot Performance Products, Inc.

Bandit 1250 Adjustable Struts Installation Tips

The installation should only take about 1 hour with basic hand tools. The tools needed are - 17mm box end with slight off set, and one more large box end for added leverage as shown. One 14 mm box end to hold the bolt heads. Blue thread lock to re install, perfect torque spec is not needed, just tighten securely.

Click on image to enlarge

Remove rear wheel to get in there, and use wrenches as shown.

Remove left foot peg assembly, then peel back rubber chain guide. Take the load off swing arm a bit and remove mounting bolts.

This photo shows the proper mounting position viewing the struts from the left side of the bike. Note! Use the bottom hole to lower or the top hole to raise the bike.

All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.