Holeshot Performance, Inc.

  Bar Snake

Solid Bar Snake Installation

  1. Read the entire installation instructions before attempting to install your Bar Snake.
  2. Observe all safe working practices while installing your Bar Snake.
  3. Remove both handle bar grips.
  4. Attach the pull wire (Installation Tool) through the nylon bushing of the Bar Snake. Approximately four inches of the wire should extend through the bushing and be securely attached by twisting the loose end around the wire four to six times.
  5. Generously grease the inside end of the handlebars you will be pulling the Bar Snake through. (Note: Any lubrication grease should work.)
  6. Grease the entire length of the Bar Snake.
  7. Insert the pull wire into and all the way through the handlebars.
  8. Attach the free end of the pull wire to a screwdriver or other similar object as to form a pulling handle.
  9. Pull the Bar Snake into and through the handlebars leaving excess sticking out both ends of the handlebars.
  10. Cut off excess length of Bar Snake from each end of the handlebars.
  11. Reinstall grips securely to handle bars.
  12. Test ride and experience the smooth vibes of your new Bar Snake!

Liquid Bar Snake Installation

  1. Read entire installation instructions before attempting to install your BAR SNAKE.
  2. Observe all safe working practices while installing your BAR SNAKE.
  3. Remove one handle bar grips/bar end weight.
  4. Secure handlebar in the upright position.
  5. Mix 2 parts together.
  6. Pour mixture into handlebar tube.
  7. Let set up for one hour.
  8. Reinstall grip/bar end weight securely to handlebars, and bars to the bike.
  9. Let cure for four hours.
  10. Test ride and experience the smooth vibes of your new BAR SNAKE!

All orders plus shipping - Prices subject to change without notice

-----

[Back]

Disclaimer
All Holeshot Performance Products are intended for closed course racing purposes only, never to be used on any road or highway anywhere in the world. Many of our products are illegal on pollution controlled vehicles so installing them is at the sole discretion of the buyer. Be sure to check your local laws. Holeshot Performance Products is not responsible for any engine damage that may occur from improper installation of any of its products. Holeshot Performance Products, Inc. ® is a trademark of Holeshot Performance. Any other product names are the trademarks of their respective holders. All rights to use this publication are exclusively owned by, and proprietary to, Holeshot Performance Products, Inc. No part of this publication or web site may be reproduced or transmitted in any form or by any means, electronic or mechanical, without first obtaining written permission from the publisher.

Copyright (c) 1998-2010. All rights reserved.