The Holeshot Slip-on really makes the Warrior come alive. You can expect to
get a gain of 3 to 7 HP in the usable part of the power band and a mind
blowing 12 to 13 foot pounds of arm stretching torque at around 3000 RPM.
Dales design is super clean and easy to install. It offers plenty of ground
clearance for the aggressive rider that likes the twisties.
The exhaust note is very healthy at wide open RPMs but can also be kept
pretty subtle at steady cruise or light throttle.
The Holeshot muffler is our 17" comp, hand crafted from stainless steel
and 6061-T6 air craft aluminum. A polished stainless elbow pipe
is included as well as top quality stainless clamps and hardware.
The Holeshot Warrior Slip-on is available fully polished or with
HPC Satin black high heat coating.
The above results were without a Dyno Jet Power Commander installed and we did not see a power gain with one on our dyno or a smoother power band. However out on the road the PC really makes it run smoother and gets rid of flat spots that most of the stock bikes have. We highly recommend it with any aftermarket pipe. The DynoJet Power Commander is an easy plug-in module that allows you to adjust the fuel mixture in the low, mid and high RPM range.
Dale will be developing a new Holeshot Big Tube Header System in the future. This will take a while so please be patient and keep an eye on our web site.
|
Our latest super clean, laser etched Holeshot Performance muffler end cap. Note! The silver and black Holeshot logo plate will not be on the muffler unless requested. It is now an option, which can be installed for an additional $5.00 per muffler. (Click image to enlarge) |
| Click here for Dyno charts |
Note! Permatex Ultra Copper High Temp Silicone is required when installing our exhaust systems. See Below.
| Road Star Warrior Slip-On | ||
| polished | Part No. W-SO | $329.00 |
| satin black | Part No. W-SOB | $354.00 |
| Holeshot logo plate (optional) | Part No. EX-NP | $5.00 |
| DynoJet Power Commander | |
| Part No. 403-211 | $329.00 |
.jpg)
|
Valco All-In-One High Temp Black Silicone is ideal for exhaust system slip fits during installation. It's one the most advanced sealers available, is resistant to extreme temperatures up to 600 degrees, and can be used in none high temp applications as well. This product is a necessity to use if your installing our Holeshot slip-on or complete header system. |
| Valco All-In-One High Temp Silicone | |
| Part No. V-HTS | $7.50 |
|
Magic Mix is known as the lazy man's polish and for a
good reason. It's absolutely the best and easiest to use
metal polish we've ever tested. It will keep your new
Holeshot Slip-on or complete system looking new
forever. It works fantastic on aluminum, stainless, chrome and our coated slip-ons or full header system. We use it daily in our workshop during final assembly, as well as, on all our personal vehicles. It can even be used to rub out fine scratches on painted clear coated finishes. Note: Magic Mix polish should not be used on our black header and muffler coatings. |
| Magic Mix Metal Polish (8 oz. bottle) | |
| Part No. MM-P | $8.95 |
 |
Magic Mix Speed Wax is a quick and easy way to give painted and clear coat surfaces a super high gloss finish. It applies a thin, wax protective coating. Speed Wax is a great product to use in between your Super Glaze carnauba waxing intervals. If you are in a hurry this is the product. It works very well on our optional ceramic black header and satin black muffler coatings. Click here to see all our detailing products. |
| Magic Mix Speed Wax (16 oz. bottle) | |
| Part No. MM-SW | $10.95 |
Disclaimer
All Holeshot Performance Products are intended for closed course racing
purposes only, never to be used on any road or highway anywhere in the world.
Many of our products are illegal on pollution controlled vehicles so installing
them is at the sole discretion of the buyer. Be sure to check your local laws.
Holeshot Performance Products is not responsible for any engine damage that
may occur from improper installation of any of its products.
Holeshot Performance Products, Inc. ® is a trademark of Holeshot
Performance. Any other product names are the trademarks of their respective
holders. All rights to use this publication are exclusively owned by, and
proprietary to, Holeshot Performance Products, Inc.
No part of this publication or
web site may be reproduced or transmitted in any form or by any means,
electronic or mechanical, without first obtaining written permission from
the publisher.
Copyright (c) 1998-2010. All rights reserved.