Holeshot Performance Products, Inc.
Report an issue with this page...

Suzuki Bandit 1250/FA EFI Supertune Pro
Installation Photo Page
(Stage 2 - Throttle Body Butterfly Removal)

NOTE: These numbered photos are to be used as a guide in conjunction with the written instruction sheet supplied with the kit. Be sure to review all photos before you start the installation, feel free to call Dale if you have any questions.
775-463-5394
1

Remove the fuel tank and side panels, loosen up the air box by removing the top mounting bolts.

2

Loosen up the air box velocity stack clamps, then pull it back off the throttle bodies.

3

Loosen up the intake manifold clamps and pull the bodies out of the manifolds. Disconnect the injector plugs, necessary hoses and wire connectors. Slide the throttle bodies out the right side of the bike. The cables can remain connected if desired. Lay a towel against the engine to prevent scratching the paint. It's not bad idea to a have another set of hands from this point on.

4

Close up of secondary butterfly

5

Use a perfect fitting phillips bit to remove the butterfly shaft screws, putting a little heat on these with a solder gun or micro propane torch first is not a bad idea.

6

Once the screws are removed, slide the butterfly out from the shaft.

7

Close up of removed secondary butterfly. Remember a good throttle body sync is recommended for the best response, fuel mileage and a smooth idle